dreamslayers.com

Ok, well I need a new gun. You may say want, I say need. I have the money, but I am deciding on what I want to do. At the moment I am deciding between an mp5 and an m4. Mp5 I like because its small and since I try to stay in cover could help me draw the gun a little faster. However the m4, I like because its a very common gun, therefore lots of parts available for customization or repairs. The m4 I want the battery in the front, not in a peq box, but I am finding it kinda hard to find the gun I want before too much customization.

Now here is what I am debating on.

m4- is the kwa s system
http://www.airsoftgi.com/product_info.p ... ts_id=3412

has the battery in the front, but I don't want the full top rail.

or the kwa m4-ris
http://www.airsoftgi.com/product_info.p ... ts_id=5631

I like the rail on top, but I don't like where the battery is.

Now, the mp5 I would buy stock and just put tightbore in, unless I hear some suggestions.
http://www.airsoftpost.com/product_info ... s_id=28372

it would look exactly like the picture.

I'd prefer an M4 over an Mp5, pretty much for the same reasons you listed above. The KWAs seem to be a solid choice from what I've heard. I know you said you don't want to use a PEQ box but you'll have to check out my PEQ15 next game. It's nice and compact and I was able to fit a 10.8v 1500mah battery inside it. If I had to pick from the three guns you listed I'd get the "kwa m4-ris" and buy an MOE foregrip. They're cheap and they look good and you can stick a lipo inside:
http://www.airsoftglobal.com/product_in ... ts_id=8642

Ok, well after exploring around i found another gun on gi. its already got magpul stuff on it, but the internals are weak in terms of fps. base gun is made by G&G, is this a decent brand? And how much upgrading of the internals would i have to do, to get it ready.

http://www.airsoftgi.com/product_info.p ... ts_id=5931

I've never used a G&G aeg before, but all of their accessories I've ever had have been top quality. That gun looks nice.

Ummm... any ideas what battery would be used?

Batteries to fit in the MOE?

I think Emile was running a lipo in his MOE, not sure about the specs though.

I found this thread that has a lipo that fits:
http://airsoft-barracks.com/forums/inde ... ntry212928

If you don't want to run a lipo, here are some nimh batteries that will work:
http://miairsoft.proboards.com/index.cg ... read=30870